XHQJ SERIES Four Link Slotting Machine
 
Photo
Name:  XHQJ SERIES Four Link Slotting Machine 
Sort:   More……More……  
Sort ID:   NO Date  
Click:  6161  Times 
Product Info:

XHQJ SERIES Four Link Slotting Machine

Appliance and Characteristic

Model XHQJ Slotting Machine is suitable for slotting and angle cutting of all kinds of the corrugates-box making. The structure is reasonable and the operation and adjustment is convenient.

SPECIFICATIONS

MODEL

XHQJ-2000

XHQJ-2500

XHQJ-3000

XHQJ-3500

Width of carton board (mm)

2000

2500

3000

3500

Size of slotting(W×D)(mm)

7.5×350

7.5×350

7.5×550

7.5×630

Size of flap cutting(W×D)(mm)

60×350

60×350

80×580

80×650

Cutting speed(pcs/min)

40

40

40

40

Power(kw)

1.5

1.5

2.2

3

Weight(kg)

1000

1200

3500

5000

Dimension(L×W×H)(mm)

2250×1170×1500

2850×1170×1500

3500×1600×1800

4000×1650×1800

Main Structure
The machine consists of feeding platform.Frame.Slotting device and angle cutting device, etc.
Operational principle

The feeding platform is connected with the frame, the slotting blade should be adjusted according to the size of the corrugate-board. Adjusting the board to control the depth of the slotting and adjust the board on the platform.
Notice: Made sure that the board should be with the board. Feeding the sheet smoothly by hand and slotting and the board

Adjustment and requirement

1 Adjustment of slotting device
Loose the locking handle, move the block front or rear to adjust the depth of the slotting, locking the handle after adjustment; the cutter and the saddle have been adjusted before leaving factory. Loose the nut of locking saddle, push the saddle gently manual to adjust the slot relative place.

2Adjust of edge cutting and angle cutting device
When fitting edge cutter and Adjust the measurement and start normal working, the measurement of the carton should be checked regularly. When the deviance is found, stop the machine and check if there is some loosing of the locking nut.

Note: Loose the locking device before adjust measurement and locking it tightly after adjustment.

Lubrication
Feed the grease or oil to the rational parts of the machine to insure the machine running normally. Feed the grease to bears once about three months.
Safeguard and Maintenance

Make sure the whole machine is settled evenly and no shaking. I f the floor is not flat, make it flat and reduce the machine vibration.
Make sure all the locking nuts are locking tightly before staring the machine;
Make sure everything is all right before connecting the wire and test idle running; make sure the direction of running is correct before starting normal working.
Each shift should keep the machine clean and make the lubrication of the machine in good conditions.
Check the fastener regularly after working for a period; locking up the loosing fastener is found.

  
Home       |       About Us       |       News       |       Products       |       Feedback       |       Contact Us